Actions

Difference between revisions of "RGB Light Show (Wired/Wireless)"

From Just in Time

m
Line 24: Line 24:
 
|}
 
|}
 
[[Category:AVR]]
 
[[Category:AVR]]
 +
==Schematic & Board==
 +
[[File:ledspot_schematic.png|752px]][[File:ledspot_board.png|480px]]

Revision as of 20:21, 6 November 2012

This page will contain a description of the wireless RGB spot controller. For now there's just the one section that describes the command bytes.

Command bytes

In general, the most significant 4 bits describe the command (room for 16 commands), the lower 2 bits may contain a spot number, depending on the command. Arguments in <angle brackets> are encoded in the lower 2 bits of the command byte.

value meaning arguments comments
0x90 wait_for_fader <fader> halts processing further commands until the given fader has finished
0xA0 fade <spot> time red green blue lets the spot fade from its current color to the given one
0xB0 set_initial <spot> red green blue sets the initial (switch-on) values for a spot
0xC0 hold none stops all faders
0xD0 resume none resumes all faders
0xE0 set <spot> red green blue sets the color for the given spot
0xF0 address new addres sets the device address of this controller, if the address button is pressend simultaneously

Schematic & Board

Ledspot schematic.pngLedspot board.png