Actions

Pre-calculated cycles for 8x3 matrix transpose

From Just in Time

Revision as of 11:30, 31 July 2016 by Danny (talk | contribs) (Created page with "When driving 8 WS2811 strips in parallel with an 8Mhz AVR we need to transpose arrays of rgb-values into groups of red-, green- and blue values (rgbrgbrgb... to rrrrrrrrgg...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

When driving 8 WS2811 strips in parallel with an 8Mhz AVR we need to transpose arrays of rgb-values into groups of red-, green- and blue values (rgbrgbrgb... to rrrrrrrrggggggggbbbbbbbb). This boils down to an in-place 8*3 matrix transpose. This again boils down to going through cycles like this:

  • pick up the value at position 1
  • place the saved value from the previous step at position 8, but first save the value at that location
  • place the saved value from the previous step at position 18, but first save the value at that location
  • place the saved value from the previous step at position 6, but first save the value at that location
  • etc, etc...

Obviously, when doing this, you'd need a description of the cycles, i.e. which values need to be moved where. For 24 values, finding the cycles could be done with a set of numbered cards. But of course, in about the same time, you could whip up a program that does this. The program looks like this:

/**

* calculate cycles along which values should be rotated in the array. See:
* https://en.wikipedia.org/wiki/In-place_matrix_transposition#Non-square_matrices:_Following_the_cycles
*
*/

void findCycles() {

   // this array describes for each cell in the array
   // where its value should go to.
   // e.g. positions[2] == 16 means that the value at
   // position 2 needs to move to position 16
   int positions[] = {
            0,  8, 16,
            1,  9, 17,
            2, 10, 18,
            3, 11, 19,
            4, 12, 20,
            5, 13, 21,
            6, 14, 22,
            7, 15, 23
   };
   while (true)
   {
       // find the starting point of the cycle
       int seed = 0;
       for (;seed<24;++seed)
       {
           if (positions[seed] != seed) break;
       }
       if (seed == 24) break; // everything in order
       // now walk the cycle
       std::cout << seed << ": ";
       int transfer = positions[seed];
       positions[seed] = -1;
       while (transfer != -1)
       {
           std::cout << transfer << " ";
           std::swap( positions[transfer], transfer);
       }
       std::cout << '\n';
   }

}