Actions

Diffusing Leds the Fast Way

From Just in Time

Revision as of 22:01, 12 May 2013 by Veecee42 (talk | contribs)

For my Led Cube project I needed diffused (opague) leds. And I didn't have any. On the instructables pages you can find instructions how to sand your leds by hand. There it is mentioned that it takes about 5 minutes per led. I don't have that kind of time (or patience) to spend 64x 5 minutes. So I went on a 'Home Improvenent' mission to use some power tools to diffuse my leds.

First step: make a fitting for the led. I used a wood plug. Wood is good, plastic might tear apart or melt sooner. The wood needs to be kinda hard too; after about 50 leds the holes seemed to widen. LedandPlug1.jpg

Second step: drill two holes in the plug using preferably a 0.8mm (or 0.7mm) drill. A PCB drill bit will likely be that size. LedPlugHoles.jpg

Third step: saw through the plug, so the led pins can come out of the bottom and the led can sit to the top of the plug tightly LedInPlug.jpg

Fourth step: get the power drill and fit the plug in. PlugInDrill.jpg


Instead of sanding paper I used a sanding sponge, because that could adjust to the shape of the led very well. It takes about 10 seconds per led to diffuse it. File:DiffusedLed

Here are the diffused result and the clear original compared: DiffusedCompared.jpg