View source for Antique Clock Start Stop Automation

[[File:Clock.jpg|200px|thumb|left|Clock]]
The antique clock from my grandmother has a unique sound. It's bells are resonating through the house. 

Unfortunately, not all residents can enjoy the sound of clock bells during the night, so normally the clock is stopped in the evening and started again in the morning. Since the latter was often forgotten, the clock was not always running and/or it was necessary to fast-forward to the correct time because we didn't restart it on time. Luckily, the design of the clock allowed for a rig that could automate the start and stop procedure.

Of course not all clocks are suitable for this kind of rig. In this case, the pendulum swings quite close to the bottom of the clock casing, thus making it possible to create a rig that sits on the bottom but stays out of sight. 
[[File:Pendulum.png|320px|thumb|right|Pendulum]]

The control is performed by an AVR Atmega88. It might be a bit overqualified for the job, but it has the advantage of having a timer that can be clocked from an external crystal, so it is very easy to make it an accurate clock using a simple watch-crystal (32.768kHz). Also, the mega88 works on voltage below 5V, so it can be powered by 4 rechargable batteries (4.8V). Since the stepper only moves about 40 seconds each day I suspect the batteries won't need to be charged that much. 

The rig contains a stepper motor to start and stop the pendulum from the clock. This actual stepper is a 5V type, so it will work with the battery power of 4.8V. It also has a 1/64 gear so it's not really fast, but compensates in sturdyness to absorb the pendulum impacts. On each side there is a switch to detect the rest position of the pendulum start/stop arm. Apart from the AVR there is only a ULN2003 to drive the stepper, a watch crystal and a LED, so it's only a 4 parts circuit.

The AVR program is very simple. The watch crystal triggers an interrupt that counts the seconds. When 12*3600 seconds have passed the clock is started. After again 12*3600 seconds the clock stops. A led light blinks each second so you can establish the startstopper is still working. Stopping the pendulum is accomplished by moving the stepper arm in vertical position very very slowly. After the pendulum has come to a full stop, the arm is returned to rest position. Starting the clock simply flips the arm over. The AVR code is [[here]]).

Here is a demo vid from the first prototype: [http://youtu.be/y-ma9XoO_XE Clock StartStopper Prototype]

After fixing the last bugs the clockstopper is airbrushed to become almost invisible and now fully functional: [http://youtu.be/8BavrgHvKEo Clock StartStopper Final]

In this case, the rig is set to a startstop timing of 60 seconds to demonstrate.