3D Miller controlled through rs-232
From Just in Time
Revision as of 22:08, 7 January 2007 by 84.27.96.54 (talk)
Revision as of 22:08, 7 January 2007 by 84.27.96.54 (talk)
This page contains some progress reporting on the 3D miller project. The project essentially contains 3 parts:
- SX firmware to control 3 stepper motors
- Electronics to drive stepper motors and keyboard
- Mechanical parts
This image shows the stepper prototype-board with one attached stepper motor, PC power supply, "keyboard" and RS-232 connection.