Difference between revisions of "3D Miller controlled through rs-232"
From Just in Time
m |
m |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 3: | Line 3: | ||
* [[SX firmware to control 3 stepper motors]] | * [[SX firmware to control 3 stepper motors]] | ||
* Electronics to drive stepper motors and keyboard | * Electronics to drive stepper motors and keyboard | ||
| − | * Mechanical parts | + | * [[Mechanical parts]] |
| − | |||
| − | |||
| + | [[Image:stepper_context.jpg|640x480px]] | ||
| + | [[Category:Projects]][[Category:SX]] | ||
This image shows the stepper prototype-board with one attached stepper motor, PC power supply, "keyboard" and RS-232 connection. | This image shows the stepper prototype-board with one attached stepper motor, PC power supply, "keyboard" and RS-232 connection. | ||
Latest revision as of 20:40, 31 July 2010
This page contains some progress reporting on the 3D miller project. The project essentially contains 3 parts:
- SX firmware to control 3 stepper motors
- Electronics to drive stepper motors and keyboard
- Mechanical parts
This image shows the stepper prototype-board with one attached stepper motor, PC power supply, "keyboard" and RS-232 connection.